- 1. The set contain two bottles marked A (resin) and B (hardener) 2. An electronic scale must be used. 3. Use in the ratio A+B (100:60) using the formula Grams of A x 0.60= Grams of B Example: 10g A x 0.60= 6g B ,
- Once properly dosed, the resin must be mixed in an irregular manner (therefore not always in the same direction) for at least 2-3 minutes. This part is fundamental, since if it is mixed only for a few seconds, at the molecular level it will not be well homogeneous, and therefore will remain soft / dull in some parts.
- The degree of hardness depends by the resting time and the catalysis temperature. In addition, the mechanical strength of the resin continues to increase up to 4-5 days after application. So after 24 hours it may still seem soft, but in the following days it will continue to harden up to become like a “hard” plastic.
- 1. Mix the resin for a longer time but slower 2. When pouring the resin, try not to let it fall from above, but pour it closer and closer to the surface 3. Once the resin is mixed let it rest for a few minutes, to make the air bubbles rise again 4. After casting, pass a heat source (heat gun or flame, NOT hair dryer) to burst the bubbles on the surface.
- Contains 200 gms of resin and 120 gms of hardener
-10%Sold out
Brustro Art Epoxy Resin and Hardener Kit 320 GMS
₹629.00
- 1. The set contain two bottles marked A (resin) and B (hardener) 2. An electronic scale must be used. 3. Use in the ratio A+B (100:60) using the formula Grams of A x 0.60= Grams of B Example: 10g A x 0.60= 6g B ,
- Once properly dosed, the resin must be mixed in an irregular manner (therefore not always in the same direction) for at least 2-3 minutes. This part is fundamental, since if it is mixed only for a few seconds, at the molecular level it will not be well homogeneous, and therefore will remain soft / dull in some parts.
- The degree of hardness depends by the resting time and the catalysis temperature. In addition, the mechanical strength of the resin continues to increase up to 4-5 days after application. So after 24 hours it may still seem soft, but in the following days it will continue to harden up to become like a “hard” plastic.
- 1. Mix the resin for a longer time but slower 2. When pouring the resin, try not to let it fall from above, but pour it closer and closer to the surface 3. Once the resin is mixed let it rest for a few minutes, to make the air bubbles rise again 4. After casting, pass a heat source (heat gun or flame, NOT hair dryer) to burst the bubbles on the surface.
- Contains 200 gms of resin and 120 gms of hardener
Out of stock
Description
Reviews
There are no reviews yet.